We found a check valve in the oil sump was installed incorrectly causing oil to be restricted to the engine and water intrusion. The front piston siezed.
We recieve alot of running and damaged Watercraft with this issue. One of the warning signs of crank bearing failure = The bearing retainer becomes dislodged or fails. When the bearing retainer fails it allows the roller bearings to not be spaced equally in the housing. The ball bearings will spin while the engine is [...]
This Impeller and pump was damaged from starting the ski in shallow water.
Running a Watercrfaft in Shallow water or near land can suck up debris off the bottom and destroy the pump or wear ring. Always make sure to have atleast 2 ft of water under the ski at idle.
Be carefull in shallow water. This guy almost did not live to tell the story.
found needle bearings inside both front and back oil pumps on the motor. The bend assembly failed and released needle bearings into the stator area of the motor.
Ski was sunk and then left over the winter.
We had a Ski come in with the front 2 spark plug grommets siliconed down to prevent water from leaking out of the head of the motor into the hull ! Motor now has 2 bad cylinders and will need to be rebuilt.
A customer reported their ski was bogging and hard to start. We found both diaphragms in the fuel pump were cracked and damaged.
Give us a call or stop by anytime. 865-257-5998
Video shows how the oil system works on all Seadoo 4 tec engines.
We had a SeaDoo RXT Jet Ski come in this week for a new motor! We found the oil level an inch or more above the high mark on the dipstick. We also observed oil inside the intake boot attached to the supercharger, after removing the intake we found oil inside the intake that was [...]
As always we offer the lowest rate for spring service in our area. 130.00 for all 4 stroke Watercraft. 65.00 for all 2 stroke Watercraft. This includes all parts and labor. Contact Us for Details | 865-257-5998
Seadoo wear ring on a 2006 GTi SE. The owner found an abandon ski rope in the Tennessee river and it found its way into the pump.
In the mid-1990s, SeaDoo began to manufacture jet skis with the DESS Key Security System. The DESS Key Security system, or Digitally Encoded Security System, is a lanyard containing a computer chip with a unique numeric code that the owner connects to the dess post on their jet ski in order to grante access to [...]
Bearing failure on the supercharger caused the impeller shaft to wobble and the impeller to rub against the hausing. The ski had less than 100 hours. :-/
Yamaha gp1200r catalytic converter fails and the inner mesh travels to the rear of the exhaust causing a restriction in exhaust flow and overheating. This can also lead to severe engine damage. Installing a D-plate removes the old catalytic converter and provides less restriction.