Watercraft Service and Repair
We found a check valve in the oil sump was installed incorrectly causing oil to be restricted to the engine and water intrusion. The front piston siezed.
We recieve alot of running and damaged Watercraft with this issue. One of the warning signs of crank bearing failure = The bearing retainer becomes dislodged or fails. When the bearing retainer fails it allows the roller bearings to not be spaced equally in the housing. The ball bearings will spin while the engine is [...]
Be carefull in shallow water. This guy almost did not live to tell the story.
Give us a call or stop by anytime. 865-257-5998
Video shows how the oil system works on all Seadoo 4 tec engines.
As always we offer the lowest rate for spring service in our area. 130.00 for all 4 stroke Watercraft. 65.00 for all 2 stroke Watercraft. This includes all parts and labor. Contact Us for Details | 865-257-5998
Seadoo wear ring on a 2006 GTi SE. The owner found an abandon ski rope in the Tennessee river and it found its way into the pump.
Bearing failure on the supercharger caused the impeller shaft to wobble and the impeller to rub against the hausing. The ski had less than 100 hours. :-/
Yamaha gp1200r catalytic converter fails and the inner mesh travels to the rear of the exhaust causing a restriction in exhaust flow and overheating. This can also lead to severe engine damage. Installing a D-plate removes the old catalytic converter and provides less restriction.
Polaris MSX 140 Piston Damage Caused by lack of oil, lower rod bearing failing and debris traveling through the cylinder ports.
Do you have any of these symptoms on your Carbureted 2-stroke engine? - No response when applying throttle. - Ski rev's when out of the water but will not in the water. - Bogging when going from idle to full throttle - Surging of revs - Intermittent or sudden cutting out of engine after planning off or applying [...]
Seems to be a trend around here. Another Kawasaki 15f rebuild. Do not think the red RTV was a great idea.
This Yamaha Jetski had a bad engine knock. We opened the engine up and found this. The entire engine including crankshaft and cases are destroyed.
Found this little guy in the case of today's build. The supercharger shaft was bent and the gear on the supercharger was missing, flywheel teeth destroyed. The customer claims the supercharger was rebuilt less than 10 hours before with an OEM Seadoo Kit.
We pulled several fuel sending units from Kawasaki 4 stroke watercraft and the units had rusty sending units. We now pull all sending units when servicing fuel related issues.
Appears that the wrong tooth gear was installed during a Supercharger service and Destroyed the flywheel and Supercharger gear.
PWC Winterization 1. Pull the drain plugs and remove all water from the hull. At this point you may also want to wash your engine compartment and outer hull. Make sure to get ALL the water out of the hull. Any water left inside the engine compartment will cause condensation and corrosion on your engine. [...]