Maintenance Matters

Watercraft live in one of the harshest environments — salt, sun, humidity. Proper maintenance is simpler than you think, and easier to maintain than to repair.

Sea-Doo Rotax 4-TEC engine

Basics

Reasons for Regular Maintenance

  • More hours of trouble-free enjoyment on the water
  • Your watercraft will be ready when you are
  • Easier and costs less to maintain than repair
  • Higher resale value when you preserve your investment

What Are the Basics?

Keep your watercraft ready to run with routine maintenance:

  • Engine oil — Change every 50 hours or once per season (4-stroke). Follow manufacturer intervals for 2-stroke oil injection.
  • Flushing — Flush with fresh water after every use, especially in saltwater. Run for 3–5 minutes at idle.
  • Battery — Keep terminals clean and tight. Charge before storage. Load-test if it's been sitting.

Pre-Launch Checklist

Take a few minutes before each ride — like pilots do before takeoff. It's key to safety and enjoyment.

  • Remove seats; allow engine compartment to air out (fuel vapors)
  • Check fuel system for leaks (visual and sniff test). Plan fuel: 1/3 out, 1/3 return, 1/3 spare
  • Inspect steering and controls
  • Ensure registration is displayed and documentation onboard
  • Check trailer hitch, chains, lights, tires
  • Check hull for damage, soft spots, cracks
  • Verify engine oil level and color
  • Check battery connections
  • Inspect jet pump area for debris
  • Ensure drain plugs are installed

Corrosion Prevention

Corrosion attacks inside and out — every day. Even freshwater boaters need to stay on top of it. Rainwater can be corrosive too.

Flush After Every Use

Raw-water cooling means your engine uses the water you're riding in. Salt, sand and contaminants build up in cooling passages. Saltwater left in the system will corrode from the inside. Flush for at least 3 minutes after each trip.

Rinse and Protect

  • Rinse — Spray down the entire exterior with fresh water after every trip. Use marine-specific cleaners, not dish soap.
  • Spray — Use a marine protectant (Yamashield, silicone spray, or equivalent) on engine and electrical connections.
  • Cover — Store under a cover when not in use.

Fuel & Fuel System

The largest source of trouble with marine engines is fuel. Ethanol in today's gas attracts water and can cause phase separation, fuel system corrosion, and engine damage.

Tips to Protect Your Fuel System

  • Add a marine fuel stabilizer (non-alcohol based) to every tank
  • Buy gas where they sell a lot of it — fresher fuel
  • For storage, fill the tank to limit condensation
  • Inspect fuel lines and connections before each trip

Engine Oil & Lube

Oil change service should be performed every 50 hours or yearly.

Use oils formulated for marine use — not automotive oil. Watercraft run at higher RPM, different temperatures, and in humid, corrosive environments.

4-Stroke

Check oil with engine at operating temperature. Use manufacturer-recommended marine oil (e.g., Yamalube 4W for Yamaha, XPS for Sea-Doo Rotax). Change at 50 hours or annually.

2-Stroke

Keep oil injection tanks full. Use the oil specified for your engine. Premix if the oil injection is bypassed.

Carb Specs · Sea-Doo Torque Specs · Yamaha Torque Specs


Electrical System

Corrosion impedes voltage. Loose or dirty connections cause intermittent or no-run conditions.

  • Keep battery terminals clean, tight, and protected
  • Visually check connections at battery, gauges, and accessories
  • Spray electrical connections with marine protectant
  • If you have a no-start or weak crank, load-test the battery

Storage

Before You Lay Up

  • Change oil and filter — don't store with dirty oil
  • Fill fuel tank and add stabilizer; run to circulate through system
  • Fog 2-stroke engines (or have a shop do it)
  • Charge battery; consider removing for winter if stored outside
  • Rinse and dry thoroughly; spray protectant
  • Cover the watercraft
Don't wait for the first freeze to winterize. Call ahead — 865-257-5998 — if you want us to handle it.

Trailers

  • Check lug nut torque; carry a jack and correct lug wrench
  • Carry a spare tire; keep it aired and ready
  • Grease bearings with marine grease
  • Inspect bunks and rollers; replace worn or rotted boards
  • Check winch cable for cuts or fraying
  • Rinse wheels and brakes after saltwater dunkings
  • Inspect for invasive species before moving between waterways

We're Here to Help

Whether you do it yourself or want us to handle maintenance, we have the parts, the knowledge, and 30+ years of experience. Sea-Doo, Yamaha, Kawasaki — we service them all.

Call 865-257-5998 Service Request